Continuously monitors the path-to-ground integrity of one operator and one ESD worksurface.
Makes the status of the operator and worksurface highly visible to the operator and supervisor.
Illuminates green to indicate proper grounding; illuminates red and sounds audible alarm when intermittent or failed connection occurs; illuminates blue to indicate standby mode.
Indicates the 8 second delay to disconnect and park the operator wrist cord without creating a false alarm.
Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface.
Sets the audible alarm volume from loud to louder.
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap's path-to-ground² and the presence of its 1 megohm safety resistor.
Grounds and monitors the worksurface with no additional wire.
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0.
Reduces the risk of electrical overstress (EOS) for the handling of sensitive components.
Identifies failures and intermittencies that inferior technologies miss.
Mounts the monitor in areas without a worksurface.
Use the Wave Distortion Monitor Verification Tester to check the test limits of Wave Distortion Monitors without removing them from their workstations.
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology.
Connects to a power cord with a IEC C13 outlet connector.
Continuously monitors the path-to-ground integrity of one operator and one ESD worksurface.
Makes the status of the operator and worksurface highly visible to the operator and supervisor.
Illuminates green to indicate proper grounding; illuminates red and sounds audible alarm when intermittent or failed connection occurs; illuminates blue to indicate standby mode.
Indicates the 8 second delay to disconnect and park the operator wrist cord without creating a false alarm.
Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface.
Sets the audible alarm volume from loud to louder.
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap's path-to-ground² and the presence of its 1 megohm safety resistor.
Grounds and monitors the worksurface with no additional wire.
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0.
Reduces the risk of electrical overstress (EOS) for the handling of sensitive components.
Identifies failures and intermittencies that inferior technologies miss.
Mounts the monitor in areas without a worksurface.
Use the Wave Distortion Monitor Verification Tester to check the test limits of Wave Distortion Monitors without removing them from their workstations.
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology.
Connects to a power cord with a IEC C13 outlet connector.
